Initial Setup; Connect Via Usb; Cable For Usb Activesync Connection - Honeywell MX9 Reference Manual

Initial Setup

The initial setup of ActiveSync must be made via a USB connection. Partnerships can only be created using USB cable
connection.

Connect via USB

The default connection type is USB Client
This is the only connection option supported on the MX9.
Connect the USB cable to the PC (the host) and the mobile device (the client) as detailed below. USB will start automatically
when the USB cable is connected.
When the MX9 loses connection, e.g., enters Suspend Mode, etc., the connection to ActiveSync will be lost. When the MX9
resumes, the ActiveSync session will automatically re-connect.

Cable for USB ActiveSync Connection:

MX9051CABLE - - MX9USB Client Cable Assembly (ActiveSync connection). USB end of cable connects to PC/Laptop
USB port.
Connect the I/O connector end of the cable to the I/O port on the bottom of the MX9
l
The USB client type A plug on the MX9 cable connects to a USB port on a PC or laptop.
l
It is not necessary to connect the power connector on the cable in order to use ActiveSync.
l
5-2
1. USB client type A plug
2. Power receptacle
3. I/O connector