Disassemble Rod Module; Disassemble Lvps Module - Sanyo PDG-DWL100 Service Manual

Multimedia projector
Hide thumbs Also See for PDG-DWL100:
Table of Contents

Advertisement

2-16 Disassemble Rod
Module
1. Unscrew 2 screws (as green circle) to
disassemble the Rod Spring (a).
2. Unscrew 1 screw (as yellow circle) to
disassemble the Rod Cover (b).
3. Disassemble the Rod(c).
Note: - Avoid touching the Rod when you
disassemble or assemble it.
- Please notice the Rod Module's direction
when you assemble it (as picture A shown).
- Ensure left edge of Rod Module contact
with the Engine base's blocks (as picture
A blue square shown).
- Rod Spring must hook in the position (as
picture B shown).
2-17 Disassemble LVPS
Module
1. Tear off the mylar (as green square).
2. Unscrew 6 screws (as red circle).
3. Unplug 1 connector (as yellow square).
4. Unplug 2 connectors (as blue square)
to take off the LVPS Module and the AC
Inlet Bracket.
5. Unplug 1 connector (as red square).
6. Disassembled the LVPS.
A
PDG-DWL100 Confidential
c
a
b
B
AC Inlet Bracket
LVPS
2-12

Advertisement

Table of Contents
loading

Table of Contents