Disassembly Lamp Module - Sanyo PDG-DSU21N Service Manual

Disassembly Lamp Module

Step
1
2
PDG-DSU21
Figure
23
Description
Turn off the projector.
If the projector is installed in a
ceiling mount, remove it from
the mount.
Unplug the power cord
Loosen the screw in the side
of the lamp cover and slide
forward and remove the
cover.
Loosen the three screws of
lamp module
Pull the lamp module out by
lamp handle.
Insert the new lamp module
into the projector and tighten
the screws.
Replace the lamp cover and
tighten the screws.
Reset the lamp timer. Press
MENU, go to Main MENU >
SETTING >LAMP COUNTER
RESET>YES, and press
MENU.
Note: Turn on the projector. If the
lamp does not turn on after the
warm-up period, please reinstall the
lamp.