Sanyo PDG-DWL100 Service Manual page 62

3. Choose 8051 file (*.hex)
- "Manley Nlink" picture will appear on the
screen.
- Ensure "MCU" is the one you chose in the
last step (as green square).
- Click "Open".
- Select the 8051 file where you put the file
in, then click "Open".
4. Program settings
- Ensure NLlNK Fixture and PC are
securely connected: the indicator lights on
green, and the state is "Connect" (as
blue square).
- Select "4MHz-20MHz Crystal" and
"Brownout detect voltage is 3.8"
(as green square).
- Click "Erase/Write(W)" (as red ellipse) to
execute 8051 FW upgrade.
5. Finish
- When 8051 FW upgrade process is
finished, "Write Chip success" will be
shown (as red square).
6. Check 8051 FW version
- Turn on the unit and get into the service
mode to check the 8051 FW version.
(To get into Service mode, please press
"Power", "Enter", "Enter" and "Menu" buttons
sequentially.)
PDG-DWL100 Confidential
5-14