Mounting The G450; Mounting On The Wall - Avaya G450 Quick Start Manual

Mounting the G450

1. Insert two mounting screws, one on either side of the rack. These will be the bottom screws of the
mounting brackets. Turn the screws only 3-4 times, so that a part of them is protruding.
2. Position the G450 in the rack so that the bottoms of the brackets are resting on the protruding screws.
3. Position the G450 in the rack. Ensure that there is adequate ventilation.
4. Insert five mounting screws on each side.
5. Tighten the mounting screws. Avoid overtightening.
6. Either tighten the two bottom-most screws inserted in step 1, or remove them completely.
7. Verify that ventilation vents are not obstructed.
8. Verify that the G450 is level and horizontal.

Mounting on the Wall

To mount the G450 on a wall, use the two mounting brackets without cable guides. You can also add a
mounting bracket with cable guides if desired (refer to
guides on page 10).
1. If the wall does not have a portion of plywood available, mount a plywood sheet at least ½ in
(1.2 cm) thick and at least 2 x 2 ft (0.6 x 0.6 m) in size, horizontally onto the wall. Make sure the
plywood screws are sufficiently anchored in the wall. Use a minimum of four wood screws and
ensure the screws are driven into wall studs, or use four wall anchors rated not less than 50
pounds (22.5 kg) shear strength each.
2. Mark the plywood with the location of the G450 bracket screw holes before fastening the plywood to
the wall.
3. Position the G450 so that its front panel is facing up, and secure it to the plywood using a minimum of
four screws (pan head at least ½ in, # 10-12 screw).
Figure 4: Wall mounting bracket placement
Figure 3: Attaching a mounting bracket with cable
Mounting on the Wall
Issue 2 December 2008 11