Configuring The G450 Using The Giw; Preparing For A Remote Configuration Of The G450 - Avaya G450 Quick Start Manual

Configuring the G450 using the GIW

1. From the Wizard Usage Options screen, select Continue the installation using this wizard, and
click Continue.
2. On the Initialize Components screen, check the options that are appropriate for your installation.
3. On the Import EPW screen, import the Electronic Pre-Installation Worksheet (EPW) that was prepared.
4. Use the IP Address screen to configure addresses and communication parameters for the G450.
Click to configure the following information for the media gateway:
a. To specify the details of the Primary Management Interface of the G450, use the PMI screen.
b. To specify SNMP community strings and trap destinations, use the SNMP screens.
c. To specify the Media Gateway Controller(s) used to manage the G450, and the Transition
Point information, use the MGC List screen. Click Ping Test to test the accessibility of each
MGC.
5. On the Firmware screen, identify the TFTP server used for file transfer, and specify the firmware
upgrade files to load.
6. Use the Change Master Key - Optional screen to optionally change the master key which is used to
encrypt gateway secrets (passwords, etc.) in the gateway configuration file.
7. If you will be using the VPN feature, use the Gateway License screen to install the gateway license file.
8. Use the G450 Modem Type Selection screen to enable a modem attached to the G450.
9. Use the Change Root Password screen to set the root password for the G450.
10. Click Finish to complete the G450 configuration.

Preparing for a remote configuration of the G450

If you need to prepare the G450 for a remote configuration, you must attach a modem and enable it using
the GIW.
1. From the Wizard Usage Options screen, select Enable the modem for remote installation, and click
Continue. The Modem Type Selection screen appears.
2. Select the type of modem you are using, and click Continue.
3. Verify that the modem parameters are correct for the type of modem that you selected. Click
Continue. The Connect Modem screen appears.
4. From the Connect Modem screen, click Finish to exit the Gateway Installation Wizard.
5. Connect the modem that you specified in Step 2.
6. Dial in to the modem to ensure that it is set up correctly.
7. A remote technician can now dial in to the G450 and complete the configuration using the CLI
interface.
Configuring a G450 without an S8300 Server
Issue 2 December 2008 27