Pioneer PDP-R03U Service Manual page 103

5
QQ
3 7 63 1515 0
Adjustment item
6 MAIN N358 Cr level
adjustment
7 MAIN N358
CONTRAST
adjustment
8 SUB N358 Y LEVEL
adjustment
9 SUB N358 COLOR
GAIN adjustment
TE
L 13942296513
(3) Component 15 kHz signal adjustment
Adjustment item
1 Setup
2 COMPONENT
15 kHz Y level adjustment
3 COMPONENT
15 kHz COLOR GAIN
adjustment
4 COMPONENT
15 kHz Cr level
adjustment
www
.
5
http://www.xiaoyu163.com
6
Description
Peak ACL: OFF
Check DC Tran 01
Press the TWIN PICTURE
key.
Description
x ao u163
y
i
6
http://www.xiaoyu163.com
7
2 9
8
Adjustment procedure
1. Adjust TB1274_MAIN output (pin (5) of P801) so that the
level shown below should be 0.3 ±0.01 Vp-p.
1. Turn off the PEAK ACL control. Adjust the output (TP815) of
IC810 to have 1.1 Vp-p from the pedestal level.
Adjusted value: 1.1 ±0.02 V
1. Select the special TWIN PICTURE settings for adjustment
(so that the same video source is reflected on MAIN/SUB).
1. Adjust TB1274_SUB output (TP806) to 0.9 ±0.02 Vp-p.
1. Adjust TB1274_SUB output (TP805) so that the level shown
below should be 0.68 ±0.01 Vp-p.
Q Q
3 6 7 1 3 1 5
Adjustment procedure
1. Select the component 15 kHz source (100% white color bar
signal).
1. Adjust TB1274_MAIN output (pin (1) of P801)
to 0.7 ±0.01 Vp-p.
1. Adjust TB1274_MAIN output (pin (3) of P801) so that the
level shown below should be 0.7 ±0.01 Vp-p.
1. Adjust TB1274_MAIN output (pin (3) of P801) so that the
level shown below should be 0.7 ±0.01 Vp-p.
co
.
PDP-R03U
7
9 4 2 8
0.3Vp-p
0.9Vp-p
0.68Vp-p
0 5 8 2 9 9 4 2 8
0.7Vp-p
0.7Vp-p
m
8
9 9
A
B
C
9 9
D
E
F
103
8