Lincoln Electric VANTAGE SVM178-B Service Manual page 250

F-62
STATOR/ROTOR REMOVAL AND REPLACEMENT (CONTINUED)
PULL COIL PC BOARD
(LEADS #265 & #227
PROCEDURE
1. Turn the engine off.
2. Using the 3/8" wrench, remove the battery cover.
Slide the battery out and disconnect the negative
battery cable.
3. Unlatch and open the engine service access door.
See Figure F.1.
TROUBLESHOOTING AND REPAIR
FIGURE F.22 – BRUSH HOLDER AND LEAD REMOVAL
#200A
#200B
#201
FIGURE F.23 – CONTROL BOX CONNECTIONS
CONTROL BOX
VANTAGE® 500
Refer to Figure F.22 for Steps 13-15.
13. Using the 3/8" wrench, remove the brush holder
access panel.
14. Using the 3/8" wrench, remove the brush holder
assembly.
15. Cut the cable tie and then label and remove brush
leads #201(-) and piggy-backed leads #200A(+)
and #200B(+) from the brush holder assembly.
(The piggy-backed leads connect closest to the
stator laminations.)
12 VDC STUD
LEADS #232L
& #232M
4. Support the door assembly. Using the 3/8" wrench,
remove the #10-24 round head screw, lock washer,
flat washer, and nut from the top corner of the door
hinge assembly, where it attaches to the roof.
Remove the support rod.
F-62