JVC KD-R960BTS Instruction Manual page 34

Wiring connection (for KD-R860BT)
Vehicle dashboard
Factory wiring
harness (vehicle)
Vehicle-specific Wiring
Harness (separately
purchased)
For more information:
Metra Electronics:
www.metraonline.com
Scosche Industries:
www.scosche.com
32
JS_JVC_KD_R960BTS_J_EN_2.indd 32
Front output
Rear/subwoofer output
To the steering
wheel remote
control adapter
Recommended
connection
Blue: To power antenna
Blue/white: To amplifier
Brown
(Not used)
Signal cord (not supplied)
Fuse (10 A)
Antenna terminal
Light blue/yellow
STEERING
WHEEL
REMOTE
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
2
Green: Rear speaker (left) *
2
Green/black *
* 1
1
JVC Amplifier *
Part list for
Remote wire
installation
(not supplied)
(A) Faceplate
Microphone input
jack ( 14)
(B) Trim plate
(C) Mounting sleeve
Ignition switch
Car fuse block
(D) Wiring harness
Separate red wire
Make this connection if your
vehicle factory wiring harness
does not have "12 V ignition
switch" wire.
* 2
You can also connect a (E) Extraction key
subwoofer speaker directly
using this lead without an
external subwoofer amplifier.
For setting, 21, 22.
Firmly connect the ground
wire of the amplifier to
the car's chassis to avoid
damaging the unit.
23/7/2014 10:38:21 AM