Machine Functionality By Weld Process; Cc-Stick - Lincoln Electric POWER FEED 10M SINGLE/DUAL SVM172-A Service Manual

B-19

MACHINE FUNCTIONALITY BY WELD PROCESS

CC-STICK

Use the following tables to review how the machine functions (output controls, arc control, Start options and weld
options) for the weld modes listed in the top table.
ARC CONTROL
ARC FORCE
(Soft)-10.0 to Arc Force adjusts the short cir-
(Crisp)+10.0 cuit current for a soft arc, or for
a forceful, driving arc. It helps to
prevent sticking and shorting
organic coated electrodes, par-
ticularity globular transfer types
such as stainless and low
hydrogen. Arc Force is espe-
cially effective for root pass on
pipe with stainless electrode
and helps to minimize spatter
for certain electrodes and pro-
cedure as with low hydrogen,
etc.
OPERATION
CC STICK MODES
Material PROCESS
Steel Stick Soft(7018)
Stick Crisp(6010)
Steel
OUTPUT CONTROL KNOBS
194
WFS AMPS
LESS MORE
OUTPUT
AMPS AMPS
OFF
DESCRIPTION
POWER FEED 10M SINGLE/DUAL
MODE
1
2
0
VOLTS TRIM
OUTPUT
ON
START OPTIONS
START TIME:
If no remote control is installed,
0 to 10 seconds
this control sets the time for the
weld output to ramp up or down
from a preset Start current to
the preset Weld current. Use
the WFS/AMP knob to adjust
Start current while the Start
Options LED is displayed.
END OPTIONS
No arc ending options are active for SMAW (Stick)
welding modes.
B-19
FUNCTION