Retest After Repair - Lincoln Electric POWER FEED 10M SINGLE/DUAL SVM172-A Service Manual

F-26
Retest a machine:
• If it is rejected under test for any reason that requires you to remove any part which
could affect the machine's electrical characteristics.
• If you repair or replace any electrical components.
1. Once the repairs have been completed, the feeder must be connected to a Powerwave
455M power source.
2. Go to the Service Navigator under Diagnostic Utility and perform the calibration procedure.
3. With the use of a load bank and the utility, all functions of the feeder can be tested.
TROUBLESHOOTING AND REPAIR

RETEST AFTER REPAIR

OR
SET UP
F-26