Procedure 13: Engineering Mode - Spirit Z 100 Service Manual

PROCEDURE 13:
1. Remove the tether cord.
2. Press and hold the START, ENTER, and STOP buttons and replaced the tether
cord.
3. The display will say ENGINEERING MODE. Press ENTER.
4. Press the UP and DOWN buttons to scroll through the following sub menus:
-Calibration
-Factory Settings
-Security
-Functions
-Display Test
-Key Test
5. Press ENTER to access the desired program.
-Calibration
Speed Calibration – In this mode, you can test the speed.
Incline Calibration – In this mode, you can test the incline.
-Factory Settings
This mode will allow you to view the Wheel size, Max inc, Max and Min speed.
Use the UP and DOWN buttons to scroll through. (They cannot be changed here)
-Security
Child Lock On/Off
Press ENTER to turn on or off. To unlock display, press START and ENTER.
-Functions
Sleep Mode On/Off. Press ENTER to turn on or off.
Units English/Metric. Press ENTER to change.
Maintenance
Lube Message Reset. Press ENTER to reset.
Odometer Reset. Press ENTER to reset.
Pause Mode On/Off. Press ENTER to turn on or off.
-Display Test
Test all LED's
-Key Test
Test all buttons on console.
Engineering mode
9