Outputs 1-6; Name; Source; Polarity - Martin Audio DX0.5 User Manual

Table of Contents

Advertisement

 
 
 
DX0.5
±0.0208 ms per click, or 
±0.007 m per click, or 
±0.023 feet per click 
 
Turning these Controls clockwise increases the delay time, while turning them anticlockwise decreases the delay time. 
The minimum and maximum delay ranges from: 
0.0000 ms – 600.9984 ms 
0.000 m – 204.339 m 
0.000 feet – 670.233 feet 
 
Press the ESC button [11] to disengage Editing. 
EQ Bypass 
EQ Bypass flattens the 5‐Band EQ on the input so you may hear exactly how it is affecting the system. By toggling the EQ Bypass 
on and off, you may quickly compare the sound with and without EQ. 
Turn the Edit2 [8] or Edit3 [9] Control to scroll between Bypass = Off [default] and Bypass =
Press the ESC button [11] to accept the new EQ Bypass mode and exit the EQ Bypass editing mode. 
5‐Band EQ 
Editing input EQ on the DX0.5 is useful for adjusting the response of the entire PA, particularly when correcting anomalies caused 
by  venue  acoustics.  It  is  standard  practice  to  use  the  input  EQ  for  this  function  leaving  the  output  EQ  for  any  cabinet  EQ 
recommended by the system manufacturer. 
Press the Enter button [10] to enter and edit the EQ bands. An arrow –> will appear next to EQ indicating that it is ready to be 
edited. 
Use the Nav/Edit1 [7] Control to change the frequency by ±1/24 octave per click. Turning this control clockwise increases the 
frequency, while turning it anti‐clockwise decreases the frequency. The frequency ranges from 20.0 Hz to 20.0 kHz. 
Use the Edit2 [8] Control to change the Q factor (bandwidth) by ±0.05 per click. Turning this Control clockwise increases the Q 
factor, while turning it anticlockwise decreases the Q. The EQ band may be configured as high or low shelf by turning it all the 
way anti‐clockwise. 
These are the EQ choices from the furthest anticlockwise option to the furthest clockwise option: 
–12 High Shelving 
–6 High Shelving 
–12 Low Shelving 
–6 Low Shelving 
0.05 – 3.00 [Parametric] 
 
To change the EQ between shelving and parametric, the gain must first be set to 0.0 dB. 
Use the Edit3 [9] Control to change the gain by ±0.5 dB per click. Turning this control clockwise increases the gain, while turning 
it anti‐clockwise decreases the gain. The gain ranges from –15.0 dB to +15.0 dB. 
Press the ESC button [11] to exit the EQ editing mode. 
Outputs 1‐6: 
Engaging Edit on Output(s) 1‐6 allows you to edit the following: 
Name 
Source 
Polarity 
Gain 
 
HAM09224 User Guide V1.0 
 
 
 
 
USER GUIDE
 
  
  
On. 
 
22 

Advertisement

Table of Contents
loading

Table of Contents