Install The Log Assembly - Heatilator GDST3831I Owner's Manual

F. Install the Log Assembly
1 1
STEP 1. CAUTION! Logs are fragile!
fi replace. See Figure 2. Remove the Mystic Embers and mineral wool and set aside. Remove the packaging from the
logs and inspect the logs for damage. To ensure that you are working on the correct side of the appliance, verify that the
pilot is on the left side. See Figure 2.
STEP 2. Log #1 (SRV2126-700):
as shown in Figure 4. The hole in the bottom of Log #1 interlocks with the head of the shoulder screw on the burner.
STEP 3. Log #2 (SRV2126-701):
log in the proper orientation to the port pattern on the burner.
48
3 3 2 2
Carefully remove the microfoam and packaged logs from the inside of the
1 1
Place Log #1 so that the large cutout on the bottom of the log fi ts over the pilot shield
2 2
Place Log #2 as shown in Figure 6 using the shoulder bolt as a guide to align the
Heatilator • GDST3831I • 2127-900 Rev. N • 6/15
Log Set Assembly: LOGS-2126
Models: ST-550T-IPI. GDST3831I
PILOT PILOT
1 1
2 2
2126-935