Table of Contents
Advertisement
Verve 3010 user guide ~ 6.1 Edition ~ 14th October '02 ~ 4710
Problem
No connection between
handset and base station.
Handset on the base does
not charge.
Handset does not ring.
You cannot dial certain
external numbers.
Your caller cannot
hear you.
The incoming caller's
number is not displayed
even though you have
Caller Display.
You keep hearing an error
beep.
42
Possible cause
Are you out of range of
the base station?
Handset is not registered.
Base station is not
switched on.
Is another handset using
the line for a long time?
Is the handset placed on
the base properly?
Are the batteries in
correctly?
The handset ringer may
be switched off.
Call barring may be set.
Secrecy is switched on.
The caller's number has
been withheld.
You have pressed the
wrong button in
a sequence.
Solution
Move closer to the base
station.
Register the handset.
Check the mains power is
connected correctly.
Maximum charging power
is only possible when no
calls are being made.
Make sure that the
handset is placed on the
base or in the charger
correctly. You will hear a
confirmation tone.
Check that you have put
the batteries in the right
way, you will hear a
confirmation tone.
See page 26 for how to
set the handset ringer.
Switch off call barring
(see page 35).
Press the S button to
speak to your caller
again.
Caller has to allow their
number to be sent.
Check the prompts in
the display or refer to
instructions in the user
guide.
Advertisement
Table of Contents
