Lincoln Electric CLASSICII SVM125-A Service Manual page 82

F-32
PROCEDURE
1. Turn the engine off.
2. Unlatch, lift and secure the right side door.
There are latches on both sides.
3. With the 1/2" wrench, disconnect the negative
battery cable.
4. With 3/8" socket wrench, remove the left case
side.
5. With the 1/2" wrench, remove the exhaust
pipe rain cap.
6. With the 1/2" and 9/16" wrenches, remove the
four nuts and bolts securing the case top and
door assembly. Remove the case top and
door assembly.
REMOVE
FASTENERS
TROUBLESHOOTING & REPAIR
ALTERNATOR ROTOR REMOVAL
AND REPLACEMENT (continued)
FIGURE F.11 – CASE FRONT REMOVAL PREPARATION
CLASSIC II
See Figure F.11 for steps 7 - 10.
7. With the 1/2" wrench, remove the battery
terminal cables. Remove negative cable
first. Then remove the two nuts and split
ring lock washers holding the battery retain-
er clamp. Remove battery.
8. With the 1/2" wrench, remove the six bolts,
nuts and lock washers holding the case front
to the frame ( three on each side).
9. With the 5/16" nut driver, remove the two
sheet metal screws from the right side of the
case front. These screws hold the output
terminal assembly to the case front.
10. With the 3/8" wrench remove the screw from
the bottom center of the case front holding
the front to the frame.
TERMINAL
CABLES
BATTERY
RETAINER
FASTENERS
F-32