Lincoln Electric CLASSICII SVM125-A Service Manual page 66

F-16
10. Measure the rotor resistance to ground.
A. Set the ohmmeter on the high scale
(X100,000).
B. Place one probe on either of the rotor
slip rings. Place the other probe on any
good, unpainted ground.
F.3.
C. Check the resistance. It should read
very high, at least 0.5 megohm (500,000
ohms).
If the test does not meet the resistance
specifications, then the rotor may be
faulty. Replace the rotor.
TROUBLESHOOTING & REPAIR
ALTERNATOR ROTOR TEST (continued)
See Figure
FIGURE F.3 – MEASURING ROTOR RESISTANCE TO GROUND
CLASSIC II
11. Replace the brushes on the slip rings.
Make sure they are seated correctly.
12. Reinstall the alternator cover.
13. Reinstall the left case side and close and
latch the right side cover door.
F-16