Lincoln Electric CLASSICII SVM125-A Service Manual page 77

F-27
PROCEDURE
1. Turn engine welder OFF.
2. Unlatch, lift and secure the right side door.
Note that there are latches at both ends of
the door.
3. Remove the cover from the exciter.
Figure F.10.
4. Turn the FINE CURRENT ADJUSTMENT
control (rheostat) to "100."
5. Using one of the leads with alligator clips,
connect the negative terminal of the 12-volt
automotive battery to the negative brush-
holder. This is the brushholder nearest the
rotor lamination. See Figure F.11 and the
Wiring Diagram.
DO NOT remove brush holder.
TROUBLESHOOTING & REPAIR
FLASHING THE FIELDS (continued)
FIGURE F.10 - FLASHING THE FIELDS
_
+
12 VOLT
BATTERY
CLASSIC II
NEGATIVE (-)
BRUSH HOLDER
POSITIVE (+)
BRUSH HOLDER
6. With the engine OFF, use the other lead with
alligator clips and touch the positive battery
terminal to the positive brushholder. Then
disconnect the leads to remove the battery
from the circuit.
See
7. Replace the exciter cover.
8. Start the welder.
should build up.
If voltage does not build up, there are a num-
ber of possible causes, such as loose or
missing brushes, open leads or poor con-
nections at the field diode bridge or between
the exciter alternator brushes and the gener-
ator brushes. See OUTPUT PROBLEMS in
the Troubleshooting Guide located in this
section of the manual for recommended
action.
F-27
The generator voltage