How Do I Delete A Condition Or A Whole Model Out Of The Campac?; I Damaged My 9Z Antenna. Can I Replace It Myself? - FUTABA 9Z WC2 Getting To Know Manual

How do I delete a condition or a whole model out of the Campac?

Delete a Condition from the
Campac, with the Campac in the
transmitter and while you are in the
model to which the condition is tied.
Delete a Model from the Campac,
with the Campac in the transmitter
and the model selected is NOT the
model to be deleted.
My Campac shows an unused model. Why won't it let me copy into that unused model?
The incredible flexibility of the Campac can lead to programming mistakes. In this example, the
modeler used the first conditions, which are intended to be individual models, as conditions in other
models. This flexibility exists in the Campac so that you can use up these extra conditions if needed;
however, the model select (MSL) reading does not realize that these conditions have already been
used. Assuming you have not also used up all other conditions in the Campac, you can simply copy
from condition 3, for example, into a higher numbered blank condition, reassign the condition select
(CSL) in the model that condition 3 is used in to the new condition number, and now condition 3 is
available as model 3.
I have an open model in my Campac, but I can't copy my helicopter into the Campac. Why not?
First, make sure you haven't made the error described in the previous paragraph. Assuming you have
not, while you may have a base model open in the Campac, you may not have enough conditions
open in the Campac to hold all the conditions needed for the model you are copying. For example,
you might have model 3 and condition 21 as the only open slots in the Campac; your helicopter has 4
conditions and so you do not have sufficient memory to store the helicopter. To solve the problem you
will need to free up additional storage space in the Campac by deleting complete models or unused
conditions.
Can I copy a baseline set-up into all Campac model memories and then just modify it?
You CAN, but we do not recommend it. You can use up all the conditions in the Campac as models;
then you have no extra conditions left for the models. In general, copying a previous or a "basic set-
up" and working from it is not recommended. There may be set-ups you're copying you've forgotten
that could get you into trouble, such as maximum sub-trims (STM), an obscure mix (PMX), etc.

I damaged my 9Z antenna. Can I replace it myself?

Replacing the antenna on this particular model radio requires major disassembly, due primarily to the
radio's complexity and number of boards installed within a standard size case. Therefore, we strongly
recommend sending it to the service center rather than attempting to replace the antenna yourself.
Open Condition select (CSL)
Select the Desired Condition
Set the Condition to Null
Close the Function
Open Model select (MSL)
Select the Desired Model
Press Delete and Confirm
Close the Function
1-4
P B F
(choose it – B through H)
H O
N R
Q B F
P (then choose the model:
A–J or P)
R L
N R