Page 2
* Modern, Light weight, easy to hold transmitter * T r a n s m i t t e r case designed so that control sticks are in a conve- nient operating position. * Antenna is angled for more effective radiation pattern. * B u i l t - i n transformer type battery charger.
Page 3
SPECIFICATION FOR FUTABA 4 / 5 CHANNEL DIGITAL PROPORTIONAL RADIOS •TRANSMITTER: Size: 71/7" x 6" x 23/4" (exclusive of antenna) Weight: 31bs including batteries Voltage: 9.6 volt DC Pulse width: 1.5 ms neutral varied 1ms for full control. •RECEIVER: Size: 2.340"...
BATTERIES: Before initial hook-up and operational check, transmitter and receiver batteries should be charged for 24 hours. BATTERY PACK "ON" FOR CHARGING CHARGING INSTRUCTIONS: Your transmitter contains a built-in transformer type nickel cadmium battery charger. A dual charging cord is packed with your radio cont- rol system.
TRANSMITTER: LOCATED ON FRONT PANEL: Two control sticks-4 trim levers-one lever for auxiliary (5th) channel operation-output meter. TOP PANEL: On-off switch-Antenna mount-Charging light indicator. BOTTOM PANEL: Two thumb screws. Removing these screws allowsacess to battery com- partment, SIDE PANNE L: Left side contains battery charging connectors.
3. Make sure that each of the servos operates correctly and responds to the individual stick and trim lever. This test should be performed at least 20 yards from the receiver. Don't test for longer than 5 minutes. Futaba FP-T4 and FP-T5 are very high put type transmitters.
The receiver should be loosely mounted in foam rubber or foam pl- astic to protect against vibration and shock. Battery pack should also be protected from vibration by wrapping in foam rubber. The receiver should also be protected from fuel by wrapping it in a plastic bag. The receiver antenna must be kept as far as possible from other wiring and metal parts.
REPAIR SERVICE To insure prompt service, please follow the instructions listed below. The gears for repairing should be sent back to the distributor or local dealer. 1. Charge batteries for at least 18 hours prior to the despatch. 2. Return only the system, separate from your installation.