Changing A Cue Point Into An Edit Point; Memory Label; Tele-File Menu - Sony SRW-5000 Operation Manual

To select the cue number directly by the numeric
buttons
Enter the cue number in the data entry window with
the numeric buttons, then press the [F9] (CUENUM
SET) button.
4
Press the PREROLL button.
4-4-6 Changing a Cue Point Into an
Edit Point
Follow the procedures below to change a selected cue
point into an edit point.
To change an edit point into an IN point
Press the SET button while holding down the IN button.
To change an edit point into an OUT point
Press the SET button while holding down the OUT button.
To change an edit point into an AUDIO IN point
Press the SET button while holding down the AUDIO IN
button.
To change an edit point into an AUDIO OUT point
Press the SET button while holding down the AUDIO
OUT button.
AUDIO IN button
IN button

4-4-7 Tele-File Menu

The Tele-File menu screen is different in HDCAM-SR and
HDCAM formats.
In HDCAM-SR format: The cassette has a memory label
attached as standard, and this screen allows
operations to read out, enter, or change the cassette ID
identification, recording format, recording
information, management information, and so on. In
the HDCAM-SR format, each recording
automatically adds recording information. However,
if the recording time is less than 2 seconds, or if when
recording ends the measurement on the spool was not
complete, then no recording information is added. In
78
4-4 CUE Menu
AUDIO OUT button
SET button
OUT button
the case of an HDCAM-SR cassette, a cassette
without a memory label is ejected.
In HDCAM format: When an MLB-1M-100 memory
label (optional) is attached to the cassette, this screen
allows operations to read out, enter, or change the cue
point information, log (IN/OUT point) information,
management information, and so on. Using this
information, cassette tape management and tape
editing efficiency can be improved.
HDCAM-SR format Tele-File menu
To open the Tele-File menu
There are two methods of accessing the Tele-File menu
screen, as follows.
• Press the [F4] (Tele-File) button while in the CUE menu.
• Select "on" for the VTR SETUP menu item 124 "Tele-
File MENU auto popup". Then, with the HOME, TC,
VIDEO, AUDIO, CUE, or SETUP menu open, insert a
cassette into the VTR.
To change the information displayed in the Tele-
File menu
Press the cursor T or t button.
Exiting the Tele-File menu
Press the [F10] (WRITE/EXIT) button. The entered or
modified data is saved to the memory label and the VTR
exits the Tele-File menu.
Note
While the data is being changed, if the write-protect setting
has been made for the whole Tele-File menu, then data
changed before the setting was made is rewritten.
To exit the Tele-File menu without saving data to
a memory label
Press the EJECT button, or press the ALT/[F2] (UNDO
ALL) buttons. After a window that confirms cancelation is
displayed, hold down the SFT button, and press the [F2]
(UNDO ALL) button. The memory label contents when
the cassette was inserted are restored.
If you accidentally press the EJECT button before
saving data to a memory label
Insert the cassette again within 30 seconds after the
ejection and press the [F10](WRITE/EXIT) button. The
data that existed before the ejection of the cassette is saved
to the memory label.
Three levels of information can be displayed in the Tele-
File menu and the levels can be scrolled to the left or right
by pressing the T or t button.