Configuring Port Settings For Cisco Wap351 - Cisco WAP131 Administration Manual

LAN
Port Settings
STEP 3
STEP 4
STEP 5
STEP 1
Cisco WAP131 and WAP351 Administration Guide
If Auto Negotiation is disabled, choose the Port Speed (10/100 Mbps) and the
duplex mode (Half- or Full-duplex).
Enable or disable the Green Ethernet Mode.
• Green Ethernet Mode supports both auto-power-down mode and EEE
(Energy Efficient Ethernet, IEEE 802.3az) mode. Green Ethernet Mode works
only when the port has auto-negotiation enabled.
• The auto-power-down mode reduces the chip power when the signal from
a link partner is not present. The WAP device automatically enters a low-
power mode when the energy on the line is lost, and it resumes normal
operation when the energy is detected.
• The EEE mode supports QUIET times during low link utilization, allowing both
side of a link to disable the portions of each PHY's operating circuit and save
power.
Click Save. The changes are saved to the Startup Configuration.

Configuring Port Settings for Cisco WAP351

To configure the port settings:
Select LAN > Port Settings.
The Port Settings Table includes the following status and configurations for all 5
Interfaces (LAN1 to LAN5):
• Port Status—Shows the current port link status.
• Port Speed—In review mode, it shows the current port speed. In edit mode,
if Auto Negotiation is disabled, select a port speed such as 100 Mbps or 10
Mbps. 1000 Mbps speed is only supported through Auto-Negotiation
enabled).
• Duplex Mode—In review mode, it shows the current port duplex mode. In
edit mode, if Auto Negotiation is disabled, select either Half-Duplex or Full-
Duplex.
• Auto Negotiation—When enabled, the port negotiates with its link partner
to set the fastest link speed and duplex mode available. When disabled, you
can manually configure the Port Speed and Duplex Mode.
4
66