Configuring Security Settings - Cisco Aironet 1300 Series Quick Start Manual

Note If the bridge's IP address changes while you are configuring the
bridge using the web-browser interface or a Telnet session over the
wired LAN, you lose your connection to the bridge. If you lose your
connection, reconnect to the bridge using its new IP address. Follow
the steps in the
Settings" section on page 12
7. Click Apply to save your settings. If you changed the IP address, you
lose your connection to the bridge. Browse to the new IP address to
reconnect to the bridge.

Configuring Security Settings

After you assign basic settings to your access point, you must configure
security settings to prevent unauthorized access to your network. Because it
is a radio device, the access point can communicate beyond the physical
boundaries of your work site.
Just as you use the Express Setup page to assign basic settings, you can use
the Express Security page to create unique SSIDs and assign one of four
security types to them. The following illustration shows the Express Security
page.
Quick Start Guide Cisco Aironet 1300 Series Access Point
"Resetting the Access Point/Bridge to Default
if you need to start over.
25