Mac Acls; Workflow To Configure Acls; Configure Ipv4 Acls - Cisco WAP131 Administration Manual

ACL
ACL Rule
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco WAP131 and WAP351 Administration Guide

MAC ACLs

MAC ACLs are Layer 2 ACLs. You can configure the rules to inspect fields of a
frame such as the source or destination MAC address, the VLAN ID, or the class of
service. When a frame enters the WAP device port, the WAP device inspects the
frame and checks the ACL rules against the content of the frame. If any of the rules
match the content, a permit or deny action is taken on the frame.

Workflow to Configure ACLs

Use the ACL Rule page to configure the ACLs and rules, and then apply the rules
to a specified interface.
These steps give a general description of how to configure ACLs:
Select ACL > ACL Rule.
Specify a name for the ACL.
Select the type of ACL to add.
Add the ACL.
Add new rules to the ACL.
Configure the match criteria for the rules.
Use the ACL Association

Configure IPv4 ACLs

To configure an IPv4 ACL:
Select ACL > ACL Rule.
In the ACL Name field, enter the name to identify the ACL. The name can contain
from 1 to 31 alphanumeric and special characters. Spaces are not allowed.
Choose IPv4 as the type of ACL from the ACL Type list. IPv4 ACLs control access
to network resources based on Layer 3 and Layer 4 criteria.
Click Add ACL.
In the ACL Rule Configuration area, configure these ACL rule parameters:
page to apply the ACL to one or more interfaces.
8
136