Connecting The Flue - Ariston Benchmark System A 24 RFF Installation And Servicing Instructions

12. Connecting the Flue

The boiler should only be installed with a flue system supplied by MTS (GB) Limited.
These kits are supplied separately to the appliance in order to respond to different installation solutions. For more information
with regard to the inlet/outlet accessories consult the accessory catalogue. The boiler is supplied ready for connection to a
concentric flue system.
N : S 24
OTE EE PAGE FOR MAXIMUM AND MINIMUM FLUE RUNS
I !!
MPORTANT
BEFORE CONNECTING THE FLUE
WATER HAS BEEN POURED INTO THE EXHAUST CONNECTION
TO FILL THE CONDENSATE TRAP
TRAP BE EMPTY THERE IS A TEMPORARY RISK OF FLUE
GASSES ESCAPING INTO THE ROOM
Warning
The exhaust gas ducts must not be in contact with or close to inflammable
material and must not pass through building structures or walls made of
inflammable material.
When replacing an old appliance, the flue system must be changed.
Ø 60/100 mm
Fig. 17
Installation with extension
(T
ABLES
, 1/4
ENSURE THAT LITRE OF
(F . 16).
IG SHOULD THE
.
5
Installation without extension
* pente
slope
A, B C)
AND
Fig. 16
Important
Ensure that the flue is not blocked.
Ensure that the flue is supported and
assembled in accordance with these
instructions.
* pente 5 mm par mètre
slope 5 mm per metre
162
12
9
3
6
150 mm
Fig. 18
19