Ip Addressing Options - Lorex LW2960 Series User Manual

14 Settings

14.3.1 IP Addressing Options

CAUTION
This section is for advanced users only.
To enable dynamic IP addressing:
NOTE
Dynamic IP addressing is enabled by default.
1. Press , then push the joystick to select Settings.
2. Select Network and push the joystick to confirm.
3. Select Network Setting.
4. Select Dynamic IP, then select On. Push the joystick to confirm.
5. Press until all menus are closed.
To enable static IP addressing:
NOTE
• A static IP address is not required for remote access to the system.
• You may have to configure your router settings if the DHCP server is enabled.
1. Press , then push the joystick to select Settings.
2. Select Network and push the joystick to confirm.
3. Select Network Setting.
4. Select Static IP.
5. Highlight the IP Address field and push the joystick. A cursor appears.
6. Move the joystick up / down to change values, and move the joystick left / right to move
the cursor.
NOTE
Ensure you enter a static IP address that is not in use by another device on your network.
7. Press when finished.
#LX400011; r. 2.0/24200/24203; en-US
37