Lorex LW2960 Series User Manual page 14

4 Installing the Camera(s)
2. Loosen the thumbscrews (1, 2) and the adjustment ring (3) by turning them counter
clockwise.
3. Adjust the angle of the cameras until the desired view is set. Tighten the thumbscrews
and the adjustment ring to secure each camera's position.
4. Connect the power cable from the cameras to the weatherproof power connector. Plug
the power adapter into a power outlet or surge protector.
NOTE
Power cables are only weatherproof when fully inserted at the connection point. Power cables may
not be submerged in water.
5. Remove the protective film from the front of the camera. If the film is not removed, it will
block the built-in microphone and affect the quality of the picture.
#LX400011; r. 2.0/24200/24203; en-US
8