Adjustment Of Air Flow Direction - Toshiba RAV-SM561KRT-E Owner's Manual

ADJUSTMENT OF AIR FLOW DIRECTION

• When the air conditioner stops, the flap (adjustment plate of up/down wind direction) directs downward
automatically.
• When the heating operation is in READY states, the flap (adjustment plate of up/down wind direction) directs
upward. The swinging starts after HEAT READY status cleared, SWING
even if the heating operation is in READY status.
About adjusting the horizontal air flow, refer to page 14.
How to set up the wind direction
1 Push 1 1
1 1
during operation.
The wind direction changes for every push of the button.
In HEAT operation
Direct the flap (adjustment plate of up/down wind direction) downward. If directing
at upward, hot air may not come to the foot.
In COOL/DRY operation
Direct the flap (adjustment plate of up/down wind direction) upward. If directing it
downward, the dew may from on the surface of the air discharge port and may drop
down.
How to start swinging
1 1 1 1 Push 1
, set the flap (adjustment
plate of up/down wind direction)
direction to the lowest position, and then
push again.
SWING is displayed and the up/down wind
direction is automatically selected.
How to stop swinging
1 1
1 1 1 Push
again while the flap is
swinging.
• The flap stops at a position when you push.
After then, if pushing
descends from the highest position.
• In COOL/DRY operation, the flap does not stop
as it directs downward. If stopping the flap as it
directs downward during swing operation, it
stops after moving to the 3
highest position.
, the wind direction
rd
position from the
3
is displayed on the remote controller
In FAN operation
Initial setup
Display when stopping the swing
Fan/Heat
operation
19
Initial setup
Initial setup
UNIT
SET CL
In all modes
Series of
operation
Cool/Dry
operation
EN