Adjustment Of Air Flow Direction; Reglage Du Sens Du Flux D'air; Einstellung Der Zuluftrichtung; Regolazione Della Direzione Del Flusso D'aria - Toshiba RAV-SM562KRT-E Owner's Manual

ADJUSTMENT OF AIR FLOW DIRECTION

• When the air conditioner stops, the flap (adjustment plate of up/down air flow direction) directs downward
automatically.
• When the heating operation is in READY states, the flap (adjustment plate of up/down air flow direction) directs
upward. The swinging starts after HEAT READY status cleared, SWING
even if the heating operation is in READY status.
About adjusting the horizontal air flow. (
How to set up the air direction
SWING/FIX
Push button.
1 1
1 Every pushing the button, the air direction changes. 1 1
In Heating operation
Set the air outlet flap downward.
If directing it upward, the hot air may not come to the foot.
In Cooling / Dry operation
Set the air outlet flap upward.
If directing it downward, the dew may fall on near the air discharge port or it drips.
How to start swinging
2 2 Push 2 2 2 SWING/FIX
button.
Set direction of the air outlet flap to the
lowest position and then push
button again.
• [SWING
] is displayed and the air direction
automatically changes upward/downward.
In case when one remote controller controls the
multiple indoor units, each indoor unit can be
selected and its air direction can be set up.
How to stop swinging
3 Push 3 3 3 3 SWING/FIX
button again during swinging
of the air outlet flap.
• The air outlet flap can be stopped at the desired
position. After then the air direction can be again
set up from the uppermost position by pushing
SWING/FIX
button.
* While the air outlet flap is set downward in
cooling/drying operation, it does not stop.
If stopping the air outlet flap which directs
downward during swinging, it stops after
moving to the 3rd position from the top
position.
4 4
4 4 4
UNIT
• To set up the air direction individually, push
UNIT
button to display each indoor unit No. in a
group control. Then set up the air direction to a
displayed indoor unit.
• If there is no display, all the indoor units can be
operated collectively.
• Every pushing
exchanges as shown in the figure.
EN
see page 14.)
SWING/FIX
UNIT
button, the display
is displayed on the remote controller
TEMP.
FILTER
RESET TEST
1, 2, 3
In FAN operation
Initial setup
Display when stopping the swing
Fan/Heat
operation
19
Initial setup
Initial setup
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
4
In all modes
Series of
operation
Cool/Dry
operation