Installation Measurements / Framing Details - FPI FP90 Owners & Installation Manual

INSTALLATION

INSTALLATION MEASUREMENTS / FRAMING DETAILS

COMBUSTION AIR
50 3/4"
(1289mm)
VENT TO OUTSIDE
COMBUSTION AIR
HEARTH MUST HAVE 1/2" (127mm)
MILLBOARD UNDER FINISH MATERIAL
WITH MIN. "K" FACTOR OF 20.07
NOTES:
1) CHASE MUST BE 60" (1524mm) WIDE INSIDE AND UNIT TO BE CENTERED IN OPENING.
2) MANTEL MIN. HEIGHT OF 18" (457mm) FROM TOP OF LOUVER OPENING TO UNDERNEATH MANTEL or 55 1/2" (1410mm) FROM BOTTOM OF UNIT.
3) MUST HAVE NON-COMBUSTIBLE MATERIAL EXTENDING 11" (280mm) ON EITHER SIDE AND 9" (229mm) ON TOP. 3/8" (10mm) THICK FINISHING
MATERIAL TO BE INSTALLED ON TOP OF THIS.
4) FRAMING IS SLIGHTLY LARGER THAN UNIT DIMENSIONS TO ALLOW FOR EASIER INSTALLATION (50 3/4", 1289mm H x 44", 1118mm W)
5) MUST MAINTAIN A MIN. OF 46" (1168mm) FROM TOP OF LOUVER OPENING TO FINISHED CEILING.
6) MUST MAINTAIN A MIN. OF 24" (610mm) TO SIDE WALL FROM THE EDGE OF THE TOP LOUVER OPENING.
7) HEARTH MUST BE A MIN. OF 40" (1016mm) WIDE x 18" (457mm) deep and 1/2" (127MM) THICK.
12
60" (1524mm) WIDE INSIDE MIN.
UNIT TO BE CENTERE
TO OUTSIDE
NOTE:
FRAMING TO BE AGAI NST
STAND-OFFS ONLY
10"
(254mm)
60"(1524mm)
WIDE INSIDE CHASE MIN.
24"
(610mm)
11"
(280mm)
40"
(1016mm)
44"
(1118mm)
D
30"
(762mm)
19" 11"
(483mm) (279mm)
38"
(965mm)
18"
(457mm)
11"
(280mm)
18"
(457mm)
3" (76mm)
STAND-OFF
2x4 FRAMING
FRONT OF UNIT ONLY
46"(1168mm)
84" (2134mm)
MIN.
CEILING
FPI FP90 Wood Fireplace