Table of Contents
Advertisement
Performing a factory reset
Performing a factory reset will reset your display to its original factory
condition.
Important:
Performing a factory reset will erase all user data (i.e.: waypoint, route
and tracks) and reset any changes to the display's settings. If you want to
backup your user data and settings refer to:
From the Homescreen:
1. Select [Settings].
2. Select [This display].
3. Scroll to the bottom of the [This display] menu.
4. Select [Factory reset].
5. Select [Yes] .
The display will reboot and the start up wizard will be displayed.
Importing user data
You can import user data (i.e.: Waypoints, Routes and Tracks) to your MFD.
1. Insert the MicroSD card that contains your user data files into a card
reader slot on your MFD or connected card reader.
2. Select [Import from card] from the Import/export page: ([Homescreen >
My data > Import/export > Import from card]).
3. Select the relevant SD card slot from the file browser and then navigate to
your User data file (.gpx).
4. Select the relevant GPX file.
Your user data has now been imported.
5. Select [OK].
5.3 Device pairing
Pairing a RMK remote keypad
You can control your MFD with an RMK keypad.
From the [This display] tab of the [Settings] menu: [Homescreen > Settings
> This display ].
1. Select [Pair keypad].
Getting started
p.71 — Import/export
2. Follow the onscreen instructions to pair your keypad.
Ensure you select the correct orientation for the keypad during the
pairing process.
3. Repeat steps 1 and 2 on each MFD you want to control from your keypad.
Note:
Please refer to the controls section of your keypad's documentation for
details on controlling MFDs using a keypad.
Clear pairing (RMK)
1. Select [Clear pairings] to unpair ALL RMK keypads currently paired with
the MFD.
Pairing with a Quantum Radar scanner
You can connect a Quantum Radar scanner to your MFD using Wi-Fi.
Pre-requisites:
• Ensure you have connected your Quantum Radar scanner in accordance
with the instructions provided with the Radar scanner.
• Ensure you know your Radar scanner's SSID and passcode.
1. Select [Pair with Quantum] from the [This display] tab: [Homescreen >
Settings > This display > Pair with Quantum].
2. Follow the onscreen instructions to pair with your Quantum Radar.
The pairing process may take several minutes to complete.
For more information on the Quantum Radar pairing process (including
troubleshooting information), refer to the Quantum Radar Installation
instructions documents.
Pairing a Bluetooth speaker
Before attempting to pair with a Bluetooth speaker, ensure that the speaker
is switched on and discoverable.
With your MFD's Bluetooth enabled:
1. From the Bluetooth settings page, select the relevant device from the
[Available devices] list.
55
Advertisement
Table of Contents
Troubleshooting
