Radar Network Connection - Raymarine eS Series Installation Instructions Manual

Transducer connection — Minn Kota transducer
1. 600 W sonar variant MFD
2. Minn Kota transducer adaptor cable (A62363)
3. Minn Kota transducer cable
4. Minn Kota transducer
For further information regarding sonar module
installation (including power connection and
mounting), refer to the installation instructions
supplied with the sonar module.
Sonar variant multifunction displays
600 W sonar variants
a67
a77
a97
a127
c97
c127
e7D
e97
e127
eS77
eS97
eS127
Important software requirements for multiple
sonar systems
If your system includes more than one source of
sonar data you must ensure that any CP300 or
CP450C sonar modules are running software version
v4.04 or later.
This applies to systems which include:
• Any number of MFD(s) with an internal sonar
module plus a CP300 and / or CP450C sonar
module; or
• No MFD(s) with an internal sonar module, but
more than one CP300 or CP450C sonar module.
This does NOT apply to any systems that do NOT
include a CP300 or CP450C sonar module.
Note: For software downloads and instructions
on how to update the software for your product(s),
visit www.raymarine.com/software.
Cables and connections
1
CHIRP DownVision TM
variants
a68
a78
a98
a128
eS78
eS98
eS128

4.10 Radar network connection

Radar units are connected to the SeaTalk
usually via a Raymarine
smaller systems the Radar may be connected
directly to the display's network connection.
Radar connected via network switch
D12259-2
1. Radar scanner
2. Raymarine
3. MFD
4. RayNet Radar cable
5. VCM (Voltage Converter Module) — (required
for Open Arrays)
6. Power connection
Radar connected directly to the display
1. Radar scanner
® network switch. On
3
1
® network switch
1
2
3
hs network,
5
6
D12252-3
D12253-3
41