Table of Contents
Advertisement
EN
4.
Wait until the display switches or hold the RESET button to apply the
changes.
Cleaning and maintenance
The equipment does not require special maintenance. The equipment does not
require recalibration when it is assembled, used and serviced according to the
instructions.
WARNING
– Before cleaning and maintenance, remove the adapter.
– Do not use solvents to clean the equipment.
▪
Clean the equipment with a soft, absorbent cloth after each use.
▪
Regularly check that all screws and nuts are tight.
▪
If necessary, lubricate the joints.
Defects and malfunctions
Despite continuous quality control, defects and malfunctions caused by individual
parts can occur in the equipment. In most cases, it will be sufficient to replace the
defective part.
1.
If the equipment does not function properly, immediately contact the dealer.
2.
Provide the model number and the serial number of the equipment to the dealer.
State the nature of the problem, conditions of use and purchase date.
Transport and storage
WARNING
– Before transport and storage, remove the adapter.
– Carry and move the equipment with at least two persons.
1.
Remain standing in front of the equipment on each side and take a sturdy grip at
the handlebars. Tilt the front of the equipment so as to lift the rear of the
equipment on the wheels. Move the equipment and carefully put the equipment
down. Place the equipment on a protective base to prevent damage to the floor
surface.
26
CROSS R 50
Advertisement
Table of Contents
