Pppoe - D-Link DIR-605L User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router. Click Save.Settings to apply them.

PPPoE:

Select Dynamic (most common) or Static. Select Static if
your ISP assigned you the IP address, subnet mask, gateway,
and DNS server addresses.
User Name: Enter your PPPoE user name.
Password: Enter your PPPoE password, then retype the password in
the next box.
Service Name: Enter the ISP service name (optional).
IP Address: Enter the IP address (Static PPPoE only).
MAC Address: The default MAC address is set to the WAN's physical
interface MAC address on the broadband router. It is not
recommended that you change the default MAC address
unless required by your ISP.
You can use the Copy.Your.PC's.MAC.Address button to
copy the MAC address of the Ethernet card installed by your
ISP and replace the WAN MAC address with the MAC address
of the router. It is not recommended that you change the
default MAC address unless required by your ISP.
Primary and
Enter the primary and secondary DNS server addresses
Secondary DNS
(Static PPPoE only).
Addresses:
D-Link DIR-605L User Manual
Internet Setup
PPPoE
16