Adjusting The Height - Epson SC-F2000 Series User Manual

SC-F2000 Series User's Guide

Adjusting the Height

The optimum height of the platen is one step lower than
the position where Platen Height Error is displayed on
the control panel.
A
Check that the platen is ejected forward.
If it is not ejected, press the } button to move the
platen forward.
B
Loosen the fixing lever under the platen.
C
Move the height adjustment lever to adjust the
height of the platen.
Recommended Positions to Start
T-shirts From label "3"
Thick From label "8"
material
Basic Printing
Height Adjustment
To adjust the height again, move the height
adjustment lever to change the recommended
position.
Note:
Labels are no longer displayed if you remove the
labeled round part to print on thick fabrics.
"Removing the Labeled Round Part" on
U
page 41
D
Tighten the fixing lever, and then secure the
height adjustment lever.
You can adjust the angle of the fixing lever.
"Adjusting the angle of the fixing lever" on
U
page 36
Note:
Print quality may decline if you do not tighten the
fixing lever.
35