Changing oil filter *
Replace the oil filter when changing the engine oil. Press the foot brake lever and
place a screwdriver or similar between foot brake lever and stopper roll so that the
1
1
oil filter cover is more accessible. Remove banjo bolt
and the three allen head
2
screws. Remove oil filter cover
and oil filter. Clean filter case, oil filter cover,
and sealing surfaces. Check oil chanel in oil filter cover if clogged.
2
3
The O-ring
need not be replaced unless it is damaged. Press the O-ring into the
1
4
groove of the oil filter cover, mount a new oil filter
on the oil filter cap and
mount the unit. Insert the 3 screws and tighten them with 5 Nm (4 ft.lb). Mount
the banjo bolt with the gaskets and tighten it with 15 Nm (11 ft.lb).
Then start the engine and check the oil system for leaks.
3
4
2
35