Changing Oil Filter - KTM 660 SMC 2004 Owner's Manual

1
1
4
2
Introduce the plastic hose into the vent hole
liters (0.16 US gallons) of engine oil into the frame's front tube. Remove
plastic hose, start engine, and let it idle (approx. 20 seconds) until oil esca-
pes at the hole
mount the plug and gasket and tighten to 25 Nm.
Let the motor run until it warms. Check the oil drain plugs and the fine
screen filter to make sure they are properly sealed. Check the level of the
motor oil. Place the motorcycle on a horizontal surface (main stand) and
wait for 5 minutes.Checking the oil level, he should be between the two
B
marks on the inspection glass, however, it must never rise above the MAX
mark. Otherwise, engine oil would get into the air filter box by way of the
engine venting system. Add engine oil, if necessary.
– I
NSUFFICIENT OIL OR POOR QUALITY OIL RESULTS IN PREMATURE WEAR OF THE
.
ENGINE
– C
HECKING THE ENGINE OIL LEVEL WHEN THE ENGINE IS COLD RESULTS IN A FALSE
READING ON THE OIL DIPSTICK AND THEREFORE AN INCORRECT OIL LEVEL
– D
O NOT OVERFILL THE ENGINE CASE
– D
O NOT UNDERFILL THE ENGINE CASE
Afterwards check the entire oil system and motor to make sure they are
properly sealed. Attach the covering of the fine screen filter to the frame
breast pipe.
NOTE: Dispose of used oil properly! Under no circumstances may used oil
be disposed of in the sewage system or in the open countryside. 1 liter
(0.264 US gallons) oil contaminates 1.000.000 liter (264.000 US gallons)
water.

Changing oil filter *

Replace the oil filter when changing the engine oil. Press the foot brake
pedal and place a screwdriver or similar between foot brake pedal and
stopper roll so that the oil filter cover is more accessible. Remove banjo bolt
1
and the three screws. Remove oil filter cover
filter case, oil filter cover and sealing areas. Make sure the oil duct in the oil
filter cover is not clogged.
2
Place the new oil filter
together with a new seal
5 Nm. Tighten the hollow screw with seals and tighten to 15 Nm.
Finally, start the engine and check the oil system for leakage.
3
B
. As soon as oil begins to leak out, switch off the engine,
!
CAUTION
.
.
3
on the connection in the oil filter cover and mount
4
. Tighten the 3 screws in the filter cover to
B
, (see page 30) and fill 0.6
!
.
2
and oil filter. Clean the
41