12
SERVICE WORK ON THE CHASSIS
12.42
Checking the frame
–
Check the chain sliding piece for wear.
»
If the bottom edge of the chain bolt is in line with or below the chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece
C00601-01
–
Check the chain guide for wear.
Info
Wear is visible on the front of the chain guide.
»
If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
B01634-01
Finishing work
–
Remove the motorcycle from the lift stand. (
x
–
Check the frame for cracks and deformation.
»
If the frame exhibits cracks or deformation due to a mechanical impact:
–
Change the frame.
401799-01
x
x
x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by Husq-
varna.
M8
15 Nm
(11.1 lbf ft)
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 41)
61