18
SERVICE WORK ON THE ENGINE
–
Position oil screen
–
Insert the pin wrench through the drill hole of the screw plug and into the engine
case on the opposite side.
–
Push the oil screen all the way into the engine case.
B01761-10
–
Mount and tighten screw plug
Guideline
Screw plug, engine oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
B01762-10
–
Remove screws
B01763-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
B01764-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with engine
oil.
–
Insert the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
B01763-11
–
Remove the oil filler plug
engine oil.
Engine oil
B01765-10
Info
Too little engine oil or poor-quality engine oil results in premature wear to the
engine.
with the O-rings on a pin wrench.
4
with the O-ring.
3
1
. Remove the oil filter cover with the O-ring.
5
out of the oil filter housing.
6
with the O-ring from the clutch cover and fill up with
8
1.50 l (1.59 qt.)
M20x1.5
15 Nm (11.1 lbf ft)
with the magnet and a new seal ring.
M12x1.5
20 Nm (14.8 lbf ft)
M5
6 Nm (4.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine
Engine oil
oil for harsh oper-
(SAE 10W/60)
ating conditions
(
and increased per-
formance
93
.
7
p. 108)
p. 108)