Removing The Front Fender; Installing The Front Fender - Husqvarna FE 450 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.16

Removing the front fender

12.17

Installing the front fender

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Disconnect plug-in connectors
–
Remove screws
–
Take the brake line and wiring harness out of the brake line guide.
C00596-10
–
Remove screws
C00572-12
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
C00572-11
–
Position the brake line and wiring harness in the brake line guide.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
–
Connect plug-in connectors
C00596-11
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
of the turn signals.
1
.
2
. Take off the fender.
3
M6
.
2
M6
of the turn signals.
3
p. 84)
p. 82)
.
1
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 82)
48