Warning Lights - Skoda Citigo Operating Instructions Manual

The maximum distance indicated in both memories is 1 999 km. The indicator is
set back to zero if this period is exceeded.
Average speed
The average speed since the memory was last erased is displayed in km/hour .
If you wish to measure the average speed over a certain period of time, you
must set the memory at the start of the new measurement to zero
Memory.
After erasing this data, no value appears in the display until you have driven
approx. 300 m.
The display is updated regularly while you are driving.
Current driving speed
The current speed, which is identical to the display of the speedometer
» Fig. 18 on page 26 is displayed.
Coolant temperature
The current coolant temperature is displayed.
Warning against excessive speeds
Set the speed limit, for example, for the maximum permissible speed in town
» page 31, Warning at excessive speeds.
Warning at excessive speeds

Read and observe on page 29 first.
Adjust the speed limit while the vehicle is stationary
›
Select the menu item  (warning when limit is exceeded).
›
Activate the speed limit option by confirming this menu item (the value flash-
es).
›
Set the desired speed limit, e.g. 50 km/h.
›
Store the speed limit by confirming the set value, or wait several seconds;
your settings will be saved automatically.
This allows you to set the speed in 5 km/h intervals.
Adjusting the speed limit while the vehicle is moving
›
Select the menu item  (warning when limit is exceeded).
›
Drive at the desired speed, e.g. 50 km/h.
›
Confirm the current speed as the speed limit.
If you wish to adjust the set speed limit, you can do so in 5 km/h intervals (e.g.
the accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).
›
Store the speed limit, or wait several seconds; your settings will be saved au-
tomatically.
Change or disable speed limit
›
Select the menu item  (warning when limit is exceeded).
›
By confirming the stored value, the speed limit is disabled.
›
By reconfirming, the option to change the speed limit is activated.
» page 29,
If the set speed limit is exceeded, an audible signal will sound as a warning. At
the same time the message  (warning against excessive speed) appears on
the display with the set limit value.
The set driving mode remains stored even after switching the ignition on and
off.
1

Read and observe
The time is set as follows.
›
Select the time display on the instrument cluster
›
Press the button
hour display appears.
›
Press button
3
button.
›
Press button
6
›
Press button
3
button.
›
Confirm the set value by pressing the button
seconds. The setting is saved automatically (the value stops flashing).

Warning lights


Introduction
This chapter contains information on the following subjects:
Handbrake

Braking system
Seat belt warning light

Alternator

Engine oil

Coolant

Automated transmission
 
on page 29 first.
» Fig. 18 on page 26 and keep it pressed down until the
6
to change the value. For quick value change, hold down the
to select the minutes display until it flashes.
to change the value. For quick value change, hold down the
again, or wait for around 5
6
Instruments and control lights
» page 29, Operation.
32
32
32
32
33
33
33

31