Skoda Citigo Operating Instructions Manual page 83

Modes and lever control

Read and observe and
The following modes can be selected with the selector lever
– Neutral
N
The power transmission to the drive wheels is interrupted in this mode.
– Reverse gear
R
Reverse gear can only be engaged when the vehicle is stationary and the en-
gine is at idling speed.
The brake pedal must be depressed before setting into position R from posi-
tion N.
- Mode for forwards travel (normal programme)
D
In mode D, the forward gears are automatically changed according to the en-
gine load, accelerator pedal actuation and driving speed.
The brake pedal must be depressed before setting into position D from posi-
tion N.
- Manual gearshift (Tiptronic)
M
Further information » page 80.
With driving mode set, the vehicle will not start up
If the vehicle does not start off, the problem may be that the selector lever is
not completely in the selected position. In such an instance, press the brake
pedal and put the selector lever into the required position.
Faults in the automatic gearbox
In the event of a fault in the automatic gearbox, warning lights may light up in
the instrument panel » page 33,
80
Driving
Fig. 84
Selector lever
on page 79 first.
» Fig.
Automated transmission.
 
An error on the automated manual transmission can become noticed, for ex-
ample, by the following.
›
Only certain gears are selected.
›
The reverse gear R cannot be used.
Manual gearshift (Tiptronic)
84.
Fig. 85 Selector lever: manual shifting/information display

Read and observe
Tiptronic mode makes it possible to manually shift gears on the selector lever.
The gearshift indicator must be observed when changing gear
Switching to manual shifting when the vehicle is stationary
›
Depress the brake pedal.
›
Press the selector lever twice to the left in the spring-tensioned position.
Switching to manual shifting during driving
›
Press the selector lever towards the left in the spring-tensioned position in
the direction of the arrow and set in position M. The selector lever position
you have engaged appears in the instrument cluster display
Shifting up gears
›
Press the selector lever forwards
Shifting down gears
›
Press the selector lever backwards
Temporarily switching to manual shifting in position D
›
Tilt the selector lever forward
If in a short time, no manual gear change takes place, then the temporary
manual shifting switches off.
and on page 79 first.
» Fig. 85 .
+
» Fig. 85 .
-
or rearwards » Fig. 85.
+ -
» page 28.
» Fig. 85 .
1
