Automated Transmission - Skoda Citigo Operating Instructions Manual

Manual gear changing
On the shift lever, the individual gear positions are shown
The gearshift indicator must be observed when changing gear
Always depress the clutch pedal all the way down. This prevents uneven wear
to the clutch.
Reverse gear is engaged
›
Stop the vehicle.
›
The clutch pedal is fully depressed.
›
Move the shift lever to the idle position switch and press down.
›
Move the shift lever fully to the right and then backwards in position R.
The reversing lights will come on once reverse gear is engaged, provided the
ignition is on.
WARNING
Never engage reverse gear when driving – risk of accident!
CAUTION
If not in the process of changing gear, do not leave your hand on the gear-
■
shift lever while driving. The pressure from the hand can cause the gearshift
mechanism to wear excessively.
When stopping on a slope, never try to hold the vehicle in position by using
■
the accelerator pedal and the clutch – this may lead to clutch damage.
Pedals
The operation of the pedals must not be hindered under any circumstances!
In the driver's footwell, only a footmat, which is attached to the two corre-
sponding attachment points may be used.
Fig. 83
The shift pattern
» Fig. 83.
» page 28.
Only use factory-supplied footmats or footmats from the range of ŠKODAOrigi-
nal Accessories, which are fitted to two attachment points.
WARNING
No objects are allowed in the driver's footwell – risk of obstruction or limi-
tation in operating the pedals!

Automated transmission


Introduction
This chapter contains information on the following subjects:
Modes and lever control
Manual gearshift (Tiptronic)
Starting-off and driving
The automatic transmission performs automatic gear changes.
The modes of the automatic transmission are adjusted by the driver by means
of the selector lever.
WARNING
No throttle when it is set before starting the mode for moving forward
■
with the selector lever - there is a risk of accident!
Never move the selector lever to mode R when driving – risk of accident!
■
Always firmly apply the handbrake before leaving the vehicle! Otherwise
■
the vehicle could then start to move and potentially cause an accident!
CAUTION
When stopping on a slope, never try to hold the vehicle using the accelerator
pedal – this may lead to gear damage.
Note
The engine can only be left on in position N, when the brake pedal is de-
■
pressed .
If the selector lever position N is accidentally selected while driving, it is first
■
necessary to release pressure on the accelerator pedal and wait for the idling
speed of the engine to be reached before the selector lever can be engaged in
the drive position.
If the N symbol flashes next to the selector lever, engage the selector lever
■
position N.
80
80
81
79
Starting-off and Driving