Seat Features - Skoda Citigo Operating Instructions Manual

Headrests - removing and installing
Fig. 46 Rear headrests: Removing and installing

Read and observe on page 52 first.
Only the real head restraints may be removed or installed.
Before removal and installation of the headrests, fold the respective seat
backrest forward » page 56.
Removing
›
Grasp the side of the head restraint with both hands and push it upwards.
›
Press the locking button and hold it in arrow direction
A
›
Use the vehicle key to press the locking button in opening
of arrow .
2
›
Remove the restraint in the direction of arrow
Installing
›
Push the head restraint far enough down in the direction of arrow
the seat backrest until the locking button clicks into place.
WARNING
With rear seats occupied, the respective head rests must be installed and
adjusted correctly - risk of fatal injury!
54
Using the system
» Fig. 46.
1
in the direction
B
.
3
into
4

Seat features


Introduction
This chapter contains information on the following subjects:
Front seat heating
Folding front passenger seat
Seat backrests
Front seat heating
The seat backrests and seats can be heated electrically.
The seat heating can only be switched on when the engine is running.
Buttons for the seat heater » Fig. 47
Left seat heating

Right seat heating

Switching on
›
Press the corresponding symbol button  or 
Pressing once switches the seat heating on at its maximum level.
With repeated pressing of the switch, the intensity of the heating is reduced
until it is switched off.
The level of the seat heating is indicated by the number of illuminated warning
lights in the switch.
Fig. 47
Buttons for heating the front
seats
» Fig. 47.
54
55
56
