Grandstream Networks GXP2130 Administration Manual page 46

Remote Disconnect
Disable Direct IP Call
Use Quick IP Call mode
Disable Conference
Disable in-call DTMF
Display
Enable sending DTMF via
specific MPKs
Mute Key Functions While
Idle
Disable Transfer
In-call dial number on
pressing transfer key
Auto-Attended Transfer
Do Not Escape # as %23 in
SIP URI
Click-To-Dial Feature
Call History Flash Writing:
Write Timeout
Call History Flash Writing:
Max Unsaved Log
Settings -> Multicast paging
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.16
remotely. The default setting is "No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disables the Conference function. The default setting is "No".
When it's set to "Yes", the DTMF digits entered during the call will not be
displayed on phone LCD. The default setting is "No".
Enables certain MPKs to send DTMF during the call. This option does
not affect Dial DTMF. The default setting is "No".
Specifies the function of mute key in idle. Default setting is "DND". When
select "Idle Mute" and press Mute key while idle, the future incoming call
will be answered with mute. When select "Disabled", Mute key will not
take effect while idle. The default setting is "No".
Disables the Transfer function. The default setting is "No".
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
If set to "Yes", the phone will use attended transfer by default. The
default setting is "No".
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Enables Click-To-Dial feature. If this feature is enabled, user could click
the green dial button on left top corner of phone's Web GUI, then choose
the account and dial to the target number. The default setting is
"Disabled".
Defines the interval (in seconds) to save the call history to phone's
flash. 0 means this option is disabled. The default value is 300
seconds.
Defines the number of unsaved logs before written to phone's flash. 0
means this option is disabled. The default value is 200 entries.
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 44 of 81