Grandstream Networks GXP2130 Administration Manual page 43

Refer-To Use Target
Contact
Transfer on Conference
Hangup
No Key Entry Timeout
(s)
Use # as Dial Key
DND Call Feature On
DND Call Feature Off
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.16
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer. The default setting is "No".
If set to "Yes", when the phone hangs up as the conference initiator, the
conference call will be transferred to the other parties so that other parties
will remain in the conference call. The default setting is "No".
Defines the timeout (in seconds) for no key entry. If no key is pressed after
the timeout, the digits will be sent out. The default value is 4 seconds. The
valid range is from 1 to 15.
Allows users to configure the "#" key as the "Send" key. If set to "Yes", the
"#" key will immediately dial out the input digits. In this case, this key is
essentially equivalent to the "Send" key. If set to "No", the "#" key is included
as part of the dialing string and please make sure the dial plan is properly
configured to allow dialing # out. The default setting is "Yes".
Configures DND feature code to turn on DND, your phone will send INVITE
with the feature code you configured to your server.
Configures DND feature code to turn off DND, you phone will send INVITE
with the feature code you configured to your server.
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 41 of 81