Accounts Page Definitions; Table 8: Account Page Definitions - Grandstream Networks GXP2130 Administration Manual

ACCOUNTS PAGE DEFINITIONS

Account x -> General Settings
Account Active
Account Name
SIP Server
Secondary SIP Server
Outbound Proxy
BLF Server
SIP User ID
Authenticate ID
Authenticate Password
Name
Voice Mail User ID
Show Account Name
Only
Account x -> Network Settings
DNS Mode
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.16

Table 8: Account Page Definitions

This field indicates whether the account is active. The default setting is "Yes".
The name associated with each account to be displayed on the LCD.
The URL or IP address, and port of the SIP server. This is provided by your
VoIP service provider (ITSP).
The URL or IP address, and port of the SIP server. This will be used when
the primary SIP server fails.
IP address or Domain name of the Primary Outbound Proxy, Media
Gateway, or Session Border Controller. It's used by the phone for Firewall or
NAT penetration in different network environments. If a symmetric NAT is
detected, STUN will not work and ONLY an Outbound Proxy can provide a
solution.
Optional server for BLF (Busy Lamp Field) feature. The BLF feature allows
a user to monitor the real-time status of another user.
User account information, provided by your VoIP service provider (ITSP). It's
usually in the form of digits similar to phone number or actually a phone
number.
SIP service subscriber's Authenticate ID used for authentication. It can be
identical to or different from the SIP User ID.
The account password required for the phone to authenticate with the ITSP
(SIP) server before the account can be registered. After it is saved, this will
appear as hidden for security purpose.
The SIP server subscriber's name (optional) that will be used for Caller ID
display.
This parameter allows you to access voice messages by pressing the
MESSAGE button on the phone. This ID is usually the VM portal access
number. For example, in UCM6100 IPPBX, *97 could be used.
When enabled, only show the action name on the idle screen without the SIP
user ID.
This parameter controls how the Search Appliance looks up IP addresses
for hostnames. There are four modes: A Record, SRV, NATPTR/SRV, Use
Configured IP. The default setting is "A Record". If the user wishes to locate
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 31 of 81