Grandstream Networks GXP2130 Administration Manual page 42

Account Ring Tone
Match Incoming Caller
ID
Ring Timeout
Send Anonymous
Anonymous Call
Rejection
Auto Answer
Allow Auto Answer by
Call-Info
Custom Call-Info for
Auto Answer
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.16
Allows users to configure the ringtone for the account. Users can choose
from different ringtones from the dropdown menu.
Specifies matching rules with number, pattern or Alert Info text. When the
incoming caller ID or Alert Info matches the rule, the phone will ring with
selected distinctive ringtone. Matching rules:

Specific caller ID number. For example, 8321123;

A defined pattern with certain length using x and + to specify, where x
could be any digit from 0 to 9. Samples:
xx+ : at least 2-digit number;
xx : only 2-digit number;
[345]xx: 3-digit number with the leading digit of 3, 4 or 5;
[6-9]xx: 3-digit number with the leading digit from 6 to 9.

Alert Info text
Users could configure the matching rule as certain text (e.g., priority) and
select the custom ring tone mapped to it. The custom ring tone will be
used if the phone receives SIP INVITE with Alert-Info header in the
following format:
Alert-Info: <http://127.0.0.1>; info=priority
Selects the distinctive ring tone for the matching rule. When the incoming
caller ID or Alert Info matches the rule, the phone will ring with the selected
ring.
Defines the timeout (in seconds) for the rings on no answer. The default
setting is 60. The valid range is from 10 to 300.
If set to "Yes", the "From" header in outgoing INVITE messages will be set
to anonymous, essentially blocking the Caller ID to be displayed. The default
setting is "No".
If set to "Yes", anonymous calls will be rejected. The default setting is "No".
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep. The default setting is
"No".
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls, based on the SIP info header sent from the
server/proxy. The default setting is "No".
Used in addition to match the contents of the info parameter in the Call-Info
header for auto answer.
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 40 of 81