Table of Contents
Advertisement
B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (3,8 cm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (10,2 cm to 18,4 cm) thick. If wall thickness is less than 4 in. (10,2 cm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (18,4 cm) a
DVP-HSM-B will be required.
15-1/8 in.
(38,4 cm)
12 in.
(30,5 cm)
Figure 16.6 SLP Series Vent Components
76
8 in.
(20,3 cm)
SLP-TRAP2
Horizontal Termination Cap
DVP-FBHT
SL-2DVP
SLP90
Heat & Glo • SL350TRSI-N-CE, SL350TRSI-PB-CE • 2033-980 Rev. L • 3/14
Heat
Shield
Term Cap
Max
Effective
Trap2
Length
SLP-TVHW
Vertical
Termination Cap
Minimum
Maximum
Effective Length
Effective Length
5-1/4 in.
9-1/4 in.
13,3 cm
23,5 cm
DVP-FBHT
Advertisement
Table of Contents
