Figure 50 Options Screen; Figure 51 10% Passive Filter Settings Screen - Liebert 30-130kVA Operation And Maintenance Manual

Options
This multiple-page screen, accessed from the third page of the SYSTEM SETTINGS screen, enables
and disables optional features which might or might not be installed in your UPS. To enable or dis-
able one of these options, do the following:
1. Highlight the option you wish to enable or disable.
2. Press UP or DOWN to toggle between enabled or disabled.
3. Press SELECT to set the desired status.
NOTE
Some of the options appearing on the following screens are reserved for future development.
Figure 50 Options screen, page 1
Highlighting 10% PASSIVE OPTIONS and pressing SELECT will bring up the following screen
allowing the Operator to decide whether or not the input trap filter should be disconnected at light
loads to prevent a leading power factor at the input. For more information, see Input Trap Filter in
the options manual.

Figure 51 10% passive filter settings screen

OPTIONS
ACTIVE FILTER
LBS
GENERATOR
AUTO RESTART
NEXT
NEXT
10% PASSIVE FILTER SETTINGS
FILTER DISCONNECT LEVEL
FILTER PREFERRED STATE
10% PASSIVE FILTER CONTACTOR
EXIT
NO
NO
NO
NO
EXIT
0
CLOSED
DISABLE
43
Operation